PCB Edge Finishers/De-nibbers


It is with regret that the Seetrax range of PCB edge-finshing equipment is no longer available for purchase. We are continuing to supply spares for the machines already in use. The following details remain for information only.

A range of edge-finshing equipment for PCB's that either require removing from the routed panel or that have already been broken out and require de-nibbing (rough-edges and burrs removed) or bevelling (chamferred edges).

Edgecut

image31

The EdgeCut is incredibly quick, up to 60% faster than the manual methods of de- burring boards. It eliminates inferior and sub-standard results caused by filing or linishing.

The EdgeCut deburrs frame centralising lugs in one pass, leaving a high quality routed edge with no need for futher inspection. The EdgeCut gives the operator total control of depth of cut with its unique micro adjuster and dial indicator.

The hardened and ground positioning table incorporates the extraction chamber for effective exhaust of dust.


Click Here For Video Guide Of The EdgeCut

BevelCut

image32

The BevelCut eliminates the inaccuracies in PCB board edge bevelling. The uniqe depth adjustment and variable angle system (between 20 degree and 45 degree) ensures perfect results on every panel. The high speed bevelling tool seamlessly chamfers the most delicate boards without lifting or burring intricate tracking such as gold fingers.

The hardened and ground positioning table incorporates the extraction chamber for effective exhaust of dust.


Click Here For Video Guide Of The BevelCut

Tab Cut

image33

Unlike other de-panelling processes which use croppers to free the panel from the scrap (often causing edge de-lamination, component failure or even worse intermittent circuit faults), this process uses high speed routers to precisely remove the webs causing no stress to either the board or components and leaves the cut undetectable. 

The machine uses a series of adjustable pins, which locate in the slots to ensure the tabs are removed accurately to either populated or unpopulated boards.

The new mark II version is easier to use than its predecessor. It now comes in its own mobile, purpose-built cabinet with fully interlocked safety switches and built in hepa-filtered extraction with bagged waste disposal.


Click Here For Video Guide Of The Tab Cut

Pneumatic Nib Croppers

image34

A versatile and precise, low-cost pneumatic de-panelling system. A dust-free cutting action with no further edge finishing required. Either hand-held or bench-mounted versions are available. A quick-cost effective method of depanelling those less sensitive boards.

Very little servicing is required due to the robust build quality and mechanically simple design. Various cutting blades are available to match the different thicknes's of milled slot (2.0, 2.3, 2.4 & 2.5mm).